فصلنامه علمی- پژوهشی اطلاعات جغرافیایی « سپهر»

فصلنامه علمی- پژوهشی اطلاعات جغرافیایی « سپهر»

بررسی صحت و دقت عملکرد سامانه مکان یابی آنی شبکه ای شمیم در استان البرز

نوع مقاله : مقاله پژوهشی

نویسندگان
1 دانشجوی کارشناسی ارشد ژئودزی، دانشکده مهندسی، دانشگاه آزاد اسلامی تهران جنوب، تهران، ایران
2 عضو هیئت علمی دانشکده مهندسی، دانشگاه آزاد، واحد تهران جنوب، تهران، ایران
چکیده
در این مقاله، عملکرد سامانه تعیین موقعیت آنی کینماتیک شبکه‌ای (NRTK) مبتنی بر شبکه تصحیحات شمیم در استان البرز ارزیابی شده است. به این منظور، مختصات حاصل از مشاهدات NRTK با استفاده از نقاط اتصال (Mount Point) مختلف، در نقاط آزمون و در فواصل متفاوت از ایستگاه مرجع، با یکدیگر مقایسه شدند. به‌منظور ارزیابی صحت نتایج، مختصات مرجع حاصل از پردازش مستقل مشاهدات استاتیک به‌عنوان مبنای مقایسه در نظر گرفته شد. این مجموعه مرجع شامل یک ایستگاه دائمی با مختصات معلوم در چارچوب ITRF2014 و سه نقطه کنترل مستقل بود که مختصات آن‌ها از طریق پردازش مستقل مشاهدات استاتیک تعیین شد. نقاط آزمون در شش حلقه شعاعی، با فواصل تقریبی ۵، ۱۰، ۱۵، ۲۰، ۲۵ و ۳۰ کیلومتر و در جهات مختلف نسبت به ایستگاه مرجع سامانه شمیم در شهر کرج، انتخاب و با استفاده از یک گیرنده چندفرکانسه برداشت شدند. برای هر نقطه، بهترین حل NRTK بر اساس کمینه‌بودن مقادیر شاخص‌های HRMS و VRMS انتخاب شد. نتایج نشان داد که ارزیابی مقایسه‌ای نسبت به مختصات مرجع مستقل در سه نقطه کنترل استاتیک انجام شد. در این سه نقطه، اختلاف افقی دوبعدی بین ۰٫۰۲۳۶ تا ۰٫۰۲۸۸ متر و اختلاف سه‌بعدی بین ۰٫۰۳۸۱ تا ۰٫۰۸۳۴ متر به دست آمد. در ۳۰ نقطه آزمون، انتخاب Mount Pointبراساس شاخص‌های HRMS و VRMSگزارش‌شده توسط گیرنده انجام شد نتایج شمارش بهترین حل‌های انتخاب‌شده در ۳۰ نقطه نشان داد که نقطه اتصال نوع VRSGG در ۱۳ نقطه، معادل ۴۳٫۳۳ درصد، به‌عنوان گزینه منتخب ثبت شده است. این گزینه در چهار حلقه از شش حلقه آزمون دست‌کم یک‌بار در میان بهترین حل‌های آن حلقه حضور داشت. این فراوانی، توصیفی از داده‌های همین مطالعه است و به‌تنهایی نشان‌دهنده برتری عمومی یا پایداری بیشتر VRSGG در همه فواصل و شرایط محیطی نیست.
کلیدواژه‌ها
موضوعات

عنوان مقاله English

Accuracy and performance assessment of the Shamim Network Real-Time Kinematic (NRTK) system in Alborz Province

نویسندگان English

Mohamad Nazari Sereshke 1
Seyed Rohallah Emadi 2
1 Master's student in geodesy, Faculty of engineering, jonob Tehran, Islamic Azad University, Tehran. Iran
2 Faculty member, Faculty of engineering, jonob Tehran Branch, Azad University, Tehran, Iran
چکیده English

Extended Abstract
Introduction
Network Real-Time Kinematic (NRTK) positioning is widely used in surveying because it can provide centimetre-level positions without a separate local base station at every site. NRTK networks combine observations from multiple permanent GNSS stations to model spatially correlated errors and generate corrections. Performance can vary with satellite geometry, atmospheric delays, network configuration, multipath, receiver characteristics, and local conditions. Different Mount Points may therefore produce different results.
This study evaluates the Shamim NRTK network in Alborz Province, Iran, at different distances from its reference station in Karaj. It compares receiver-reported indicators for different Mount Points and examines coordinate discrepancies against independent static coordinates.
Materials and Methods
Thirty test points were distributed across six approximate radial rings at distances of 5, 10, 15, 20, 25, and 30 km from the Shamim reference station in Karaj. Points represented different directions and local settings. At each point, observations were collected using nine Mount Point options: VRS, PRS, NEAREST, i-MAXGG, VRSGG, NearestGG, Nearest4, VRS4, and i-MAX4. The receiver sampling interval was one second, the satellite elevation mask was set to 10 degrees, and the average PDOP during the observations was 1.8. Each planned session lasted 150 seconds. Of the 270 planned point–Mount Point sessions, 160 produced fixed (FIX) solutions and were retained; 110 solutions that did not achieve FIX status were excluded.
For each test point, the selected solution was determined using the receiver-reported horizontal and vertical root mean square indicators (HRMS and VRMS), which were treated as internal quality estimates rather than coordinate errors. VRMS was used as a secondary criterion in cases of a tie. The selected options were counted across the points and rings.
Independent reference coordinates were determined for three static control points in the 30 km ring using approximately four-hour GNSS sessions. The IGS permanent station TEHN00IRN in Tehran was used as the processing reference. Coordinates were expressed in ITRF2014 and projected to UTM Zone 39N. NRTK and static coordinates were compared in the local east, north, and height components. Their differences were defined as follows:



and the three-dimensional discrepancy as


Results and Discussion
At the three static control points, horizontal two-dimensional discrepancies ranged from 0.0236 to 0.0288 m, while three-dimensional discrepancies ranged from 0.0382 to 0.0834 m. These values describe agreement at the three control locations under the observation conditions of this study, not accuracy throughout the entire area.
Among the 30 test points, M20_1, located in the 20 km ring, provided the lowest reported values for the selected solution using VRSGG: HRMS of 0.006 m and VRMS of 0.010 m. These favourable receiver-reported indicators do not prove that the coordinate discrepancy from an independent reference was the smallest.
The frequency analysis showed that VRSGG was selected at 13 points (43.33%), VRS4 at 8 (26.67%), and i-MAX4 at 5 (16.67%). VRS was selected twice, while PRS and i-MAXGG were each selected once. VRSGG appeared among the selected solutions in several distance rings. The selected Mount Point varied with location: PRS and i-MAX4 were also selected at 5 and 10 km, while VRSGG appeared more often in several rings from 15 to 30 km. These counts are descriptive and do not prove general superiority or temporal stability under other conditions.
These assessment approaches must be distinguished: HRMS and VRMS are receiver-reported indicators, whereas the two- and three-dimensional discrepancies quantify coordinate differences at the three independent controls. A small receiver-reported RMS value does not necessarily mean a similarly small discrepancy from the reference.
Conclusion
The Shamim network provided centimetre-level solutions at the surveyed sites under the observed conditions. Mount Point selection varied among points and distance rings and should not be based on distance alone. Although VRSGG was selected most often, its 13 selections (43.33%) do not establish general superiority. HRMS and VRMS are receiver-reported indicators; discrepancies against independent static controls provide a separate assessment of positional agreement. Because only three controls and a limited observation period were used, the findings apply to the surveyed area and conditions. Further work should use more independent controls, repeated sessions, and different atmospheric conditions.

کلیدواژه‌ها English

Shamim NRTK system
GNSS
Positioning accuracy
Mount point optimization
VRMS

مقالات آماده انتشار، پذیرفته شده
انتشار آنلاین از 28 آبان 1405